Installation

Lay the sticker on a flat surface with the image side up and use a credit card to rub evenly over the whole sticker.

Carefully peel off the paper backing from the transfer tape and decal. The vinyl decal should remain affixed to the transfer tape. The sticky side of the vinyl decal and tape is now exposed.

Place the decal and transfer tape on a clean, dry surface. Use a credit card on the transfer tape to smooth the decal onto the surface, working from the center out.

Remove the transfer tape starting from the corner. It works best to pull back across the sticker at a low angle, rather than pulling up. If the decal lifts off the surface with the transfer tape, lay the tape back down, smooth with the credit card then try peeling again.